TG-01Core Hand Tools
The four tools that handle most small fixes. What the numbers on the label mean and how to hold each one properly.
- SPEC450 g hammer
- RANGE6-in-1 driver
- KEY3 pliers · 200 mm spanner
- READ9 min · checklist
TG-02Drill/Driver & Bits
Voltage, chuck size, clutch settings and the bit types you actually need for wood, metal and masonry.
- SPEC12–20 V
- RANGE10–13 mm chuck
- KEY4 bit types · clutch 1–20
- READ11 min · checklist
TG-03Measuring & Marking
Tape measure, levels, speed square, stud detector and pencil. How to read the blade and check each tool for accuracy.
- SPEC8 m tape
- RANGE600 mm level
- KEY180 mm square · 1 mm marks
- READ10 min · checklist
TG-04Fasteners & Wall Plugs
Screws, nails and the fixing types for plasterboard, plaster and masonry. Read a screw label and pick the right fixing.
- SPEC4.0 × 30 mm
- RANGE5 fixing types
- KEYpilot sizes · load notes
- READ10 min · checklist
TG-05Saws & Cutting
Hand saw, hacksaw, utility knife and when a jigsaw or circular saw makes sense. TPI, blades and straight cuts.
- SPEC8–12 TPI
- RANGE24 TPI hacksaw
- KEYsnap-off knife · jigsaw optional
- READ9 min · checklist
TG-06Safety Gear & PPE
Eye, ear, lung and hand protection explained, plus first aid and a pre-project safety routine you can print.
- SPECEN 166 eyewear
- RANGESNR ear rating
- KEYFFP2 / FFP3 · cut-rated gloves
- READ9 min · checklist